-
(Ⅰ) How to deal with flow marks on injection-molded parts?
2024-09-27
(1) P: Poor flow of the molten material leads to the formation of concentric flow marks resembling growth rings on the surface of injection-molded parts, centered around the gate. When low-temperature, high-viscosity molten material with poor flow performance is injected into the cavity in a semi-cured, fluctuating state through the injection port and runner, the material flows along the cavity su...
view more
-
Overview of 8 Non-Destructive Testing (NDT) Methods for Composite Materials
2024-11-01
Composite materials are new materials created through advanced material preparation techniques that combine components with different properties in an optimized manner. In the 1940s, due to the needs of the aviation industry, fiberglass-reinforced plastics (commonly known as fiberglass) were developed, marking the beginning of the term "composite materials." After the 1950s, high-strength and high...
view more
-
Do you know which nylon materials are used in new energy vehicles?
2024-11-15
In the new energy vehicle materials industry, polymers encompass plastics, rubber, silicone materials, and composite fiber materials such as carbon fiber. To avoid safety hazards associated with high-voltage systems, materials for new energy vehicles must not only be heat-resistant but also flame-retardant. Therefore, Xiamen LFT has introduced a flame-retardant polyamide solution targeting manufac...
view more
e-mail
English
français
Deutsch
русский
italiano
español
português
العربية
日本語
한국의
中文